Thingiverse
Raspberry Pi ZeroW case
par ulrikk
13
Téléchargements
6
Likes
0
Makes
I really liked Superrei's design. Really nice with the hinge. Since I needed a case to lift with my drone without wide open ports I closed the HDMI and one USB port.
In the final end I would add another 0.5 mm on th hinge side to make a smaller gap in the hinge.I was also looking to make it thinner to reduce weight, but I couldn't figure it out how do it in Fusion.
Finality I intend to spray the inside with graphite to screen the Zero to reduce interference with the DJI drone.
In the final end I would add another 0.5 mm on th hinge side to make a smaller gap in the hinge.I was also looking to make it thinner to reduce weight, but I couldn't figure it out how do it in Fusion.
Finality I intend to spray the inside with graphite to screen the Zero to reduce interference with the DJI drone.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
