Thingiverse
Remote Control Holder
by Battman540
29
Downloads
21
Likes
0
Makes
I designed this remote holder to keep them organized. They were either falling off the table or piled on top of each other.
I just swapped out my A/V receiver for a better one and the remote was quite a bit shorter than the old one so I have added in some spacers so that you can adjust the height of each remote.
The end most slot is raised 10mm to put the most often used remote in. The one to rule the rest.....
I just swapped out my A/V receiver for a better one and the remote was quite a bit shorter than the old one so I have added in some spacers so that you can adjust the height of each remote.
The end most slot is raised 10mm to put the most often used remote in. The one to rule the rest.....
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
