Thingiverse
Remote Control Holder
por Battman540
29
Descargas
21
Likes
0
Makes
I designed this remote holder to keep them organized. They were either falling off the table or piled on top of each other.
I just swapped out my A/V receiver for a better one and the remote was quite a bit shorter than the old one so I have added in some spacers so that you can adjust the height of each remote.
The end most slot is raised 10mm to put the most often used remote in. The one to rule the rest.....
I just swapped out my A/V receiver for a better one and the remote was quite a bit shorter than the old one so I have added in some spacers so that you can adjust the height of each remote.
The end most slot is raised 10mm to put the most often used remote in. The one to rule the rest.....
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
