Removable Sag Indicator

Simple print-in-place removable ring that can be used to help measure sag on your bike suspension if you don't have or don't like the little rubber O-ring that higher-end suspension setups come with. This is my first time trying to design anything with a clasp (snap??) or a PIP hinge so if needed later i might have to adjust the tolerances for more extreme size differences. If you have issues getting the clasp freed, i just used my keys to help pull it up. Model is made for a 34MM stanchion, but if you need a different size simply just resize the part in your slicer. I've been able to downsize the part to 28MM, and while it was a little tricky to get the moving pieces to break apart, I did get it eventually and it works great. If you're having troubles with the halves on the print bed fusing together, you might have to fine tune your starting layer, or just use a raft. Shouldn't damage your stanchion as long as you make sure its clean before putting it on, but still use at your own ris