Thingiverse
RepRap RoofTop Spool Stand
von 4ndy
88
Downloads
104
Likes
10
Makes
I made this as a very simplistic way to support a spool of plastic over my RepRap, since I'm short on desk space.
It works just fine with charlespax's nice cardboard spool design:
http://www.thingiverse.com/thing:1550
I have now also designed my own printable spool that will fit on this stand:
http://www.thingiverse.com/thing:9039
The slot at the top takes up to a 10mm shaft, while the slots at the bottom are sized to grab hold of the top 8mm studding on a RepRap Mendel.
It's designed to require as little assembly as possible, and you should be able to make one out of wood too, although that might be a bit wasteful, as it's also designed to be lightweight.
If people really want it to be secure on there, then I'll make a design with flanges to bolt on with something like a y-bar clamp.
The included bushings are for gluing to a cheap cardboard spool so that if you use threaded rod it doesn't cut away at the cardboard.
It works just fine with charlespax's nice cardboard spool design:
http://www.thingiverse.com/thing:1550
I have now also designed my own printable spool that will fit on this stand:
http://www.thingiverse.com/thing:9039
The slot at the top takes up to a 10mm shaft, while the slots at the bottom are sized to grab hold of the top 8mm studding on a RepRap Mendel.
It's designed to require as little assembly as possible, and you should be able to make one out of wood too, although that might be a bit wasteful, as it's also designed to be lightweight.
If people really want it to be secure on there, then I'll make a design with flanges to bolt on with something like a y-bar clamp.
The included bushings are for gluing to a cheap cardboard spool so that if you use threaded rod it doesn't cut away at the cardboard.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
