rg353v Case

This is a semi fitted protective shell case for the rg353v retro gaming system. The case is designed with room to add in stick on EPA foam sheets commonly available from Amazon and craft stores to pad the system. The pivot wings to hold it in assume m2 flat head screws no more than 12mm long, the holes printed for them may need to be drilled a bit to allow the screw to tap in (depends on your material and printer.

the case allows charging the unit while stored.

I printed mine in PLA and it seems to hold up just fine in my cargo shorts pocket. Walls of the unit are 2mm thick.

The shell can be printed upright with no support material.

The EPA foam I used inside of mine is the Amazon stuff that comes in sheets that are cutable on a cricut. (maybe 1.5-2mm thick).