Thingiverse
Runcam Split V2 case
von danarrib
10
Downloads
13
Likes
0
Makes
*** Photos are from the first prototype. STLs were updated since. ***
This is a Runcam Split (V1 and V2) case. It's intended to make it easier to use this camera on a fixed wing model aircraft.
It has the exact internal space to fit the Runcam Split PCB, and the camera can be mounted at any up or downtilt angle.
The lower part is open, so you can do all the wiring thought the bottom part and make it invisible.
The cap locks on pressure, so no complex locking mechanisms are required. If you need you can trim it using a file. The flat part is the top one.
This is a Runcam Split (V1 and V2) case. It's intended to make it easier to use this camera on a fixed wing model aircraft.
It has the exact internal space to fit the Runcam Split PCB, and the camera can be mounted at any up or downtilt angle.
The lower part is open, so you can do all the wiring thought the bottom part and make it invisible.
The cap locks on pressure, so no complex locking mechanisms are required. If you need you can trim it using a file. The flat part is the top one.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
