Thingiverse
Runcam Split V2 case
par danarrib
10
Téléchargements
13
Likes
0
Makes
*** Photos are from the first prototype. STLs were updated since. ***
This is a Runcam Split (V1 and V2) case. It's intended to make it easier to use this camera on a fixed wing model aircraft.
It has the exact internal space to fit the Runcam Split PCB, and the camera can be mounted at any up or downtilt angle.
The lower part is open, so you can do all the wiring thought the bottom part and make it invisible.
The cap locks on pressure, so no complex locking mechanisms are required. If you need you can trim it using a file. The flat part is the top one.
This is a Runcam Split (V1 and V2) case. It's intended to make it easier to use this camera on a fixed wing model aircraft.
It has the exact internal space to fit the Runcam Split PCB, and the camera can be mounted at any up or downtilt angle.
The lower part is open, so you can do all the wiring thought the bottom part and make it invisible.
The cap locks on pressure, so no complex locking mechanisms are required. If you need you can trim it using a file. The flat part is the top one.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
