Thingiverse
Scraper handle
por McMosfet
5
Descargas
2
Likes
0
Makes
To mount the the handle, heat up the scraper in your kitchen then just press it into the hole. Be careful because it will deviate.
The hole is about 1.5mm.
About the infill, you'll have to know wich use you are going to do, the more infill, the more strong it will be.
I was trying to take out some cork pasted to the floor, and I already splited the handle in half. It was a tough work.
The hole is about 1.5mm.
About the infill, you'll have to know wich use you are going to do, the more infill, the more strong it will be.
I was trying to take out some cork pasted to the floor, and I already splited the handle in half. It was a tough work.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
