Sculpfun_S9_compact_endstop

My version of an endstop isn´t the most perfect, but it needs only the two sensors and about 20 cm of 4 wire control cable.

I left al little hole on the back of the mounting which is large enough for the controll cable.

This version avoids the two cables to the usually chosen corner (front left) and the more problematic cable to the gantry.

The sensors i used i bought a few years ago for my MPCNC. They were available an Amazon:
UEETEK 10 stücke 250 V 5A SPDT 1NO 1NC Momentary Scharnier Rollenhebel Mikroschalter 3 Pins