Seeed Grove Flame Sensor Case

I am experimenting with flame sensors for hopefully improving the safety of a laser device and chose this sensor to use for the project. I need a case for them with different options, so here it is! This device is usable in ESPHome as a binary sensor. Here is how it might be configured on GPIO1:binary_sensor: - platform: gpio pin: GPIO1 name: "Flame Sensor 1" id: pefs1I do not vouch for the safety or accuracy of this device and any fire safety application you may use it for is not my responsibility.Required For Assembly:2x M2 Ruthex/CNC Kitchen or other similar sized inserts2x M2 washers2x M2 screws - M2x12 may work, but if the inserts are too far in you need longer onesGrove temperature sensorMagnetic Mount Variant: You can use one or two 8x2mm square or disc magnets. Smaller magnets will also fit but be less strong. Screw Mount Variant: The hole for the screw in the base is 5mm wide. Do not use a screw head that is higher than about 4mm without being very careful about not shorting a