Thingiverse
Sensor Test Rig
by DjDemonD
1
Downloads
1
Likes
0
Makes
See it on YouTube:
https://youtu.be/mq37Aqcgydk
Test rig STLs, as requested by people on YouTube. For testing 3D printer Z sensors/micro switches.
You will also need the firmware and gcodes which are https://1drv.ms/u/s!Apv79JfGbPIwkdFAaFO96Qat8RNuuA?e=gdZNOQ
You'll need an AT MEGA 2560 arduino, a ramps shield, or some other form of microcontroller that can run marlin, some smooth rods, some bearings, a lead screw of some type.
Its basically one axis from a 3D printer, or simple CNC/engraver. I am not going to provide full build instructions, if you cannot figure out how to build it, should you be testing sensors?
https://youtu.be/mq37Aqcgydk
Test rig STLs, as requested by people on YouTube. For testing 3D printer Z sensors/micro switches.
You will also need the firmware and gcodes which are https://1drv.ms/u/s!Apv79JfGbPIwkdFAaFO96Qat8RNuuA?e=gdZNOQ
You'll need an AT MEGA 2560 arduino, a ramps shield, or some other form of microcontroller that can run marlin, some smooth rods, some bearings, a lead screw of some type.
Its basically one axis from a 3D printer, or simple CNC/engraver. I am not going to provide full build instructions, if you cannot figure out how to build it, should you be testing sensors?
DjDemonD also publishes on
1 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!