Thingiverse
Sensor Test Rig
door DjDemonD
1
Downloads
1
Likes
0
Makes
See it on YouTube:
https://youtu.be/mq37Aqcgydk
Test rig STLs, as requested by people on YouTube. For testing 3D printer Z sensors/micro switches.
You will also need the firmware and gcodes which are https://1drv.ms/u/s!Apv79JfGbPIwkdFAaFO96Qat8RNuuA?e=gdZNOQ
You'll need an AT MEGA 2560 arduino, a ramps shield, or some other form of microcontroller that can run marlin, some smooth rods, some bearings, a lead screw of some type.
Its basically one axis from a 3D printer, or simple CNC/engraver. I am not going to provide full build instructions, if you cannot figure out how to build it, should you be testing sensors?
https://youtu.be/mq37Aqcgydk
Test rig STLs, as requested by people on YouTube. For testing 3D printer Z sensors/micro switches.
You will also need the firmware and gcodes which are https://1drv.ms/u/s!Apv79JfGbPIwkdFAaFO96Qat8RNuuA?e=gdZNOQ
You'll need an AT MEGA 2560 arduino, a ramps shield, or some other form of microcontroller that can run marlin, some smooth rods, some bearings, a lead screw of some type.
Its basically one axis from a 3D printer, or simple CNC/engraver. I am not going to provide full build instructions, if you cannot figure out how to build it, should you be testing sensors?
DjDemonD publiceert ook op
1 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!