Thingiverse
SimpleWallet V2
por boramerts
7
Descargas
10
Likes
0
Makes
I've upgraded my SimpleWallet design and made it thinner. It still can fit up to 6 cards inside.
Printing the slider part was hard and looked bad with supports, so I removed it. Now you can just open it by sliding your finger on the side.
Currently, the wallet does not have a compartment for cash. But I am planning to add it in the next version again.
Tips:
-Adjust the bed temperature so the outside part holds on to the bed properly and the inside part does not warp during printing.
-Putting the parts together is a little bit hard, you need to use some force but try not to break it.
Printing the slider part was hard and looked bad with supports, so I removed it. Now you can just open it by sliding your finger on the side.
Currently, the wallet does not have a compartment for cash. But I am planning to add it in the next version again.
Tips:
-Adjust the bed temperature so the outside part holds on to the bed properly and the inside part does not warp during printing.
-Putting the parts together is a little bit hard, you need to use some force but try not to break it.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
