Thingiverse
SimpleWallet V2
door boramerts
7
Downloads
10
Likes
0
Makes
I've upgraded my SimpleWallet design and made it thinner. It still can fit up to 6 cards inside.
Printing the slider part was hard and looked bad with supports, so I removed it. Now you can just open it by sliding your finger on the side.
Currently, the wallet does not have a compartment for cash. But I am planning to add it in the next version again.
Tips:
-Adjust the bed temperature so the outside part holds on to the bed properly and the inside part does not warp during printing.
-Putting the parts together is a little bit hard, you need to use some force but try not to break it.
Printing the slider part was hard and looked bad with supports, so I removed it. Now you can just open it by sliding your finger on the side.
Currently, the wallet does not have a compartment for cash. But I am planning to add it in the next version again.
Tips:
-Adjust the bed temperature so the outside part holds on to the bed properly and the inside part does not warp during printing.
-Putting the parts together is a little bit hard, you need to use some force but try not to break it.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
