Thingiverse
single handle gamecube controller stand
door opuc
0
Downloads
5
Likes
0
Makes
Couldn't find a display for my ASCII gamecube controller, so I made 2 separate smaller parts so I could display it.
ASCII controller keyboard part hangs lower than where the stands sits, so it does touch, however it still is able to display it nice. I was even able to support it with just 1, but thought it looked better with 2.
Left/Right with GC logo, or you can use the no logo and just mirror it to get the left side.
Can probably make it a lot more pretty or efficient but it's a solution nonetheless.
ASCII controller keyboard part hangs lower than where the stands sits, so it does touch, however it still is able to display it nice. I was even able to support it with just 1, but thought it looked better with 2.
Left/Right with GC logo, or you can use the no logo and just mirror it to get the left side.
Can probably make it a lot more pretty or efficient but it's a solution nonetheless.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
