Thingiverse
Skate Riser Lights
von wafflejock
9
Downloads
8
Likes
0
Makes
These are risers with space inside to put LEDs, a battery, charging board, and switch that can be screwed in as a riser between the trucks and the board (albeit a big one). Plus side is the riser will be protected by the base of the trucks so there should be little chance of it getting banged up or destroyed in a head on collision with a curb or the like.
Used a TP4056 for recharging a 350mAh battery that fits in the case and a small slide switch for turning power on and off, will post the PCB design once it has been completed.
---
V2 is only .5" tall so closer to a "regular" riser size, made some of these using silicone molds for more rigidity but should work fine if printed from ABS or Nylon (would suggest pretty high infill 50% or more if you plan to just use the 3D printed versions, tried with PLA but it breaks down eventually and cracks).
Used a TP4056 for recharging a 350mAh battery that fits in the case and a small slide switch for turning power on and off, will post the PCB design once it has been completed.
---
V2 is only .5" tall so closer to a "regular" riser size, made some of these using silicone molds for more rigidity but should work fine if printed from ABS or Nylon (would suggest pretty high infill 50% or more if you plan to just use the 3D printed versions, tried with PLA but it breaks down eventually and cracks).
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
