Thingiverse
Skate Riser Lights
di wafflejock
9
Download
8
Likes
0
Makes
These are risers with space inside to put LEDs, a battery, charging board, and switch that can be screwed in as a riser between the trucks and the board (albeit a big one). Plus side is the riser will be protected by the base of the trucks so there should be little chance of it getting banged up or destroyed in a head on collision with a curb or the like.
Used a TP4056 for recharging a 350mAh battery that fits in the case and a small slide switch for turning power on and off, will post the PCB design once it has been completed.
---
V2 is only .5" tall so closer to a "regular" riser size, made some of these using silicone molds for more rigidity but should work fine if printed from ABS or Nylon (would suggest pretty high infill 50% or more if you plan to just use the 3D printed versions, tried with PLA but it breaks down eventually and cracks).
Used a TP4056 for recharging a 350mAh battery that fits in the case and a small slide switch for turning power on and off, will post the PCB design once it has been completed.
---
V2 is only .5" tall so closer to a "regular" riser size, made some of these using silicone molds for more rigidity but should work fine if printed from ABS or Nylon (would suggest pretty high infill 50% or more if you plan to just use the 3D printed versions, tried with PLA but it breaks down eventually and cracks).
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
