Thingiverse
SkyMule engine mount
by FgDude
3
Downloads
5
Likes
0
Makes
This is a engine mount for the SkyMule so you can use a non bell type engine on it.
I have used the MTN 28-30 1200kv but you can use any BL engine in the 28-30 to 28-35 range. Swapping the engine out is easy.
I have made no holes for mounting the engine because the outcome of the wires of the BL engines are sometimes on different places and they must be coming out on the underside of the pod.
I have printed this in pla, use a thick bottom and top layer when using infill (25%).
ABS is better as some engines can get hot in flight.
I have used the MTN 28-30 1200kv but you can use any BL engine in the 28-30 to 28-35 range. Swapping the engine out is easy.
I have made no holes for mounting the engine because the outcome of the wires of the BL engines are sometimes on different places and they must be coming out on the underside of the pod.
I have printed this in pla, use a thick bottom and top layer when using infill (25%).
ABS is better as some engines can get hot in flight.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!