Slicer Discord
Snap Shut Deck Box - Basic Version – 3D-printbaar model van MakerWorld MakerWorld
Other Toys & Games

Snap Shut Deck Box - Basic Version

484 Downloads
191 Likes
198 Makes
Model downloaden
This is the Snap Shut Deck Box, Basic version. It holds either 100 cards double sleeved or 60 cards plus the Accessory Box inside. Use the Accessory box to carry all of your dice, coins, and tokens that you would need for your game of choice. This box is perfect for any of your favourite TCGs like Pokemon, Magic the Gathering, One Piece, YuGiOh, Digimon, Dragon Ball, or whatever else you may want to use it for!This whole set can be printed without supports if your bridging is good, otherwise a little support on the lid may be needed where the clips slide in. Make sure to print the clips on their side so you get the most strength out of them and then just slide them into the bottom piece.Go check out the other versions available on Thangs including the Window version to show off your favourite card or Leader/Commander or the Stylized versions too!
Categorie
Other Toys & Games
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Waarom?
print-in-place ontwerp · geen supports
Zonder supports Print-in-place
Supports 0/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
Software
Cura, PrusaSlicer of vergelijkbaar
Zelfde ontwerper, meer platforms

Maple3DPrinting publiceert ook op

14 extra modellen op 3 andere platforms

Geverifieerd door overeenkomende modeltitels op platforms.
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie