Slicer Discord
Snap Shut Deck Box - Basic Version – Modelo 3D imprimible de MakerWorld MakerWorld
Other Toys & Games

Snap Shut Deck Box - Basic Version

484 Descargas
191 Likes
198 Makes
Ver Modelo
This is the Snap Shut Deck Box, Basic version. It holds either 100 cards double sleeved or 60 cards plus the Accessory Box inside. Use the Accessory box to carry all of your dice, coins, and tokens that you would need for your game of choice. This box is perfect for any of your favourite TCGs like Pokemon, Magic the Gathering, One Piece, YuGiOh, Digimon, Dragon Ball, or whatever else you may want to use it for!This whole set can be printed without supports if your bridging is good, otherwise a little support on the lid may be needed where the clips slide in. Make sure to print the clips on their side so you get the most strength out of them and then just slide them into the bottom piece.Go check out the other versions available on Thangs including the Window version to show off your favourite card or Leader/Commander or the Stylized versions too!
Categoría
Other Toys & Games
Fuente
MakerWorld
Publicado
Actualizado
Lo que necesitas para imprimir: Principiante Baja confianza
¿Por qué?
diseño print-in-place · sin soportes
Sin soportes Print-in-place
Soportes 0/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 0/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
Software
Cura, PrusaSlicer o similar
Mismo diseñador, más plataformas

Maple3DPrinting también publica en

14 modelos adicionales en 3 plataformas más

Verificado por coincidencia de títulos de modelos entre plataformas.
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección