Slicer Discord
Snap Shut Deck Box - Basic Version – 3D-Druckmodell von MakerWorld MakerWorld
Other Toys & Games

Snap Shut Deck Box - Basic Version

484 Downloads
191 Likes
198 Makes
Zum Modell
This is the Snap Shut Deck Box, Basic version. It holds either 100 cards double sleeved or 60 cards plus the Accessory Box inside. Use the Accessory box to carry all of your dice, coins, and tokens that you would need for your game of choice. This box is perfect for any of your favourite TCGs like Pokemon, Magic the Gathering, One Piece, YuGiOh, Digimon, Dragon Ball, or whatever else you may want to use it for!This whole set can be printed without supports if your bridging is good, otherwise a little support on the lid may be needed where the clips slide in. Make sure to print the clips on their side so you get the most strength out of them and then just slide them into the bottom piece.Go check out the other versions available on Thangs including the Window version to show off your favourite card or Leader/Commander or the Stylized versions too!
Kategorie
Other Toys & Games
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Warum?
Print-in-place-Design · keine Supports
Ohne Supports Print-in-place
Supports 0/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

Maple3DPrinting veröffentlicht auch auf

14 zusätzliche Modelle auf 3 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen