Thingiverse
Snapmaker Cableclip
von SchnabsiX
98
Downloads
38
Likes
0
Makes
A little screw-less cable clip for the snapmaker.
The clip is designed to be a friction fit in the threaded holes. Depending on your filament, printer, etc you might have to print it 1-2% bigger or use some tape (I use electrical tape) on the pegs to have a tighter friction fit.
The flat cables of the snapmaker are loose in the clip. If you wanna have them tight you can use some tape or heat shrink on the cable (also prevents chaffing on the cable).
The clip is designed to be a friction fit in the threaded holes. Depending on your filament, printer, etc you might have to print it 1-2% bigger or use some tape (I use electrical tape) on the pegs to have a tighter friction fit.
The flat cables of the snapmaker are loose in the clip. If you wanna have them tight you can use some tape or heat shrink on the cable (also prevents chaffing on the cable).
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
