Thingiverse
Snapmaker Cableclip
door SchnabsiX
98
Downloads
38
Likes
0
Makes
A little screw-less cable clip for the snapmaker.
The clip is designed to be a friction fit in the threaded holes. Depending on your filament, printer, etc you might have to print it 1-2% bigger or use some tape (I use electrical tape) on the pegs to have a tighter friction fit.
The flat cables of the snapmaker are loose in the clip. If you wanna have them tight you can use some tape or heat shrink on the cable (also prevents chaffing on the cable).
The clip is designed to be a friction fit in the threaded holes. Depending on your filament, printer, etc you might have to print it 1-2% bigger or use some tape (I use electrical tape) on the pegs to have a tighter friction fit.
The flat cables of the snapmaker are loose in the clip. If you wanna have them tight you can use some tape or heat shrink on the cable (also prevents chaffing on the cable).
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
