Thingiverse

SoapDish

von MacNeill

4 Downloads

3 Likes

0 Makes

This is more an additional part rather than a remix for this really cool design by [krayvis](http://www.thingiverse.com/krayvis/about)!

https://www.thingiverse.com/thing:3704406

Due to conversion issues (inch to mm) I scaled his design up and printed it. Then I needed a dish where it should fit in. So I took measures of the printed part and designed this one. I don't remember the exact factor but I calculated that it should be about 2880% to fit in the dish. To be sure you can try to fit both files in the preview of your slicer software.

I coatet both parts and glued those little rubber feet (Ø 8mm) under the dish.

kitchen kitchen sink kitchen tool soap dish soap holder sponge drainer sponge holder kitchen kitchen sink kitchen tool soap dish soap holder sponge drainer sponge holder

Quelle

Thingiverse

Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz

Einteilig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 0/3

Drucker

FDM / FFF

Dateiformat