Thingiverse
Specs Switch Mount
von skip1776
9
Downloads
8
Likes
0
Makes
This mount connects an AbleNet Specs Switch to a standard 1/4"-20 camera mount. It uses three 6-32 x 12 mm screws to mount to the switch and a 1/4"-20 x 9/16" T-nut inserted into the center to accommodate the camera mount.
There are two versions of this thing. Version A is slightly rounded on the side that connects to the camera mount, whereas Version B has a concave fillet.
There are two versions of this thing. Version A is slightly rounded on the side that connects to the camera mount, whereas Version B has a concave fillet.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
