Thingiverse
Spile
von BEServices
7
Downloads
7
Likes
0
Makes
Best to print on its side. Seem to break easily when printed standing up.
Sized for a 1/2" drill bit. Drill a hole in the tree about 1 - 2" at a 20 degree up angle. Tap the splile into the tree with a rubber mallet. Cut a hole in a gallon jug and hang over the end of the splile.
www.Buhler3DPrints.com
Sized for a 1/2" drill bit. Drill a hole in the tree about 1 - 2" at a 20 degree up angle. Tap the splile into the tree with a rubber mallet. Cut a hole in a gallon jug and hang over the end of the splile.
www.Buhler3DPrints.com
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
