Thingiverse
Spile
door BEServices
7
Downloads
7
Likes
0
Makes
Best to print on its side. Seem to break easily when printed standing up.
Sized for a 1/2" drill bit. Drill a hole in the tree about 1 - 2" at a 20 degree up angle. Tap the splile into the tree with a rubber mallet. Cut a hole in a gallon jug and hang over the end of the splile.
www.Buhler3DPrints.com
Sized for a 1/2" drill bit. Drill a hole in the tree about 1 - 2" at a 20 degree up angle. Tap the splile into the tree with a rubber mallet. Cut a hole in a gallon jug and hang over the end of the splile.
www.Buhler3DPrints.com
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
