Thingiverse
spongeholder
von thony7sk8ter
5
Downloads
3
Likes
0
Makes
I got annoyed by the water on my kitchen counter after I had used my sponge so decided to make a holder for it. found a few on the site here but decided to make one that fit my counter perfectly.
It is designed for a round sink.
it is 20 cm wide.
from the back to the front of the holder: the left side is 11cm, the middle is 7cm and right side is 9 cm
the "water slide" is a bit higher since it needs to go over the sink. You need to print that with support
It is designed for a round sink.
it is 20 cm wide.
from the back to the front of the holder: the left side is 11cm, the middle is 7cm and right side is 9 cm
the "water slide" is a bit higher since it needs to go over the sink. You need to print that with support
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
