Thingiverse
spongeholder
di thony7sk8ter
5
Download
3
Likes
0
Makes
I got annoyed by the water on my kitchen counter after I had used my sponge so decided to make a holder for it. found a few on the site here but decided to make one that fit my counter perfectly.
It is designed for a round sink.
it is 20 cm wide.
from the back to the front of the holder: the left side is 11cm, the middle is 7cm and right side is 9 cm
the "water slide" is a bit higher since it needs to go over the sink. You need to print that with support
It is designed for a round sink.
it is 20 cm wide.
from the back to the front of the holder: the left side is 11cm, the middle is 7cm and right side is 9 cm
the "water slide" is a bit higher since it needs to go over the sink. You need to print that with support
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
