Thingiverse
spool bracket remix
door DaveThornton
7
Downloads
6
Likes
0
Makes
spool bracket back piece for this thing http://www.thingiverse.com/thing:374576
i made it because i couldn't figure out where to attach the bowden tube on the original one i made a couple designs on them because why not i had it open in tinkercad. i made it fit a 1/4' tube because that was the smallest one i could find for the project(the hole in the file is a lil bigger than the one in the picture).
added front pieces with same designs
i made it because i couldn't figure out where to attach the bowden tube on the original one i made a couple designs on them because why not i had it open in tinkercad. i made it fit a 1/4' tube because that was the smallest one i could find for the project(the hole in the file is a lil bigger than the one in the picture).
added front pieces with same designs
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
