Thingiverse

Spoolholder

par DonJoe

14 Téléchargements

13 Likes

0 Makes

This is a very basic Spoolholder I designed to put on top of my Ikea Lack enclosure for my Prusa i3. You can print it laying down on the back side and you need supports on the top of the spoolholder where the little overhang is, but its very easy to remove. It takes about 12 hours to print and mine was about 180 grams with 0,2mm layer hight and 50% infill. Make shure to use high infill to get maximum strengh. A 1kg spool works well but i wouldn't go with anything heavier. You can use it as it is or attatch some rubber feet or attatch it to a surface with double sided tape.

Source

Thingiverse

Ce qu'il faut pour imprimer: Débutant Confiance faible

Monobloc

Supports 1/3

Assemblage 0/3

Réglages 1/3

Taille du plateau 0/3

Post-traitement 0/3

Imprimante

FDM / FFF

Format de fichier