Thingiverse

Spoolholder

door DonJoe

14 Downloads

13 Likes

0 Makes

This is a very basic Spoolholder I designed to put on top of my Ikea Lack enclosure for my Prusa i3. You can print it laying down on the back side and you need supports on the top of the spoolholder where the little overhang is, but its very easy to remove. It takes about 12 hours to print and mine was about 180 grams with 0,2mm layer hight and 50% infill. Make shure to use high infill to get maximum strengh. A 1kg spool works well but i wouldn't go with anything heavier. You can use it as it is or attatch some rubber feet or attatch it to a surface with double sided tape.

Bron

Thingiverse

Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid

Eendelig

Supports 1/3

Montage 0/3

Instellingen 1/3

Bedgrootte 0/3

Nabewerking 0/3

Printer

FDM / FFF

Bestandsformaat