Thingiverse
Stackable Hydroponic Planter
door Raspbian
2
Downloads
2
Likes
0
Makes
This is my design for a hydroponic seedling starter. This design goals:
1. Based on Aerogarden pod size.
2. One plant.
3. Pots can be connected together on two sides.
4. LED Light can be connected.
Because of the way 3D Printing works, the bottom of the pot is literally a sieve. It must be coated with a food safe epoxy, such as Artesian.
The LettuceGrow pods are too big for this planter. Perhaps a later version will be just a bit bigger.
LEDTower is coming.
1. Based on Aerogarden pod size.
2. One plant.
3. Pots can be connected together on two sides.
4. LED Light can be connected.
Because of the way 3D Printing works, the bottom of the pot is literally a sieve. It must be coated with a food safe epoxy, such as Artesian.
The LettuceGrow pods are too big for this planter. Perhaps a later version will be just a bit bigger.
LEDTower is coming.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
