Thingiverse
Stackable IKEA NOJIG - Distancer
door Morcatko
16
Downloads
23
Likes
0
Makes
Ikea recently introduced very nice, cheap and useless containers. However adding these distancers/legs into a corner allows conversion to stackable containers
###Print settings:
- sharp corners need time to cool down so either print 4 at once or use slow speed.
- PLA
- 0.6mm nozzle,
- 0.4mm layer height
- 2 perimeters
- Rotate by 45°, Set rear seam
###Print settings:
- sharp corners need time to cool down so either print 4 at once or use slow speed.
- PLA
- 0.6mm nozzle,
- 0.4mm layer height
- 2 perimeters
- Rotate by 45°, Set rear seam
Morcatko publiceert ook op
7 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
