Thingiverse
Tablet Stand
por FLX3D
3
Descargas
12
Likes
0
Makes
This is a tablet stand where you can adjust the angel: 45, 60 or 82 degrees. I made it because i didn't have a stand which works in the bed / on the blanket. This one is perfect.
If you have a bigger or smaller tablet / phone device you can change the length of the metal bars.
The Print takes about 1,5 h.
Additional you need a metal bar approx. 60 cm long and a saw to cut it to the right length.
I can recommend copper brazing rods Ø 3mm
I didn't use any glue.
If you have a bigger or smaller tablet / phone device you can change the length of the metal bars.
The Print takes about 1,5 h.
Additional you need a metal bar approx. 60 cm long and a saw to cut it to the right length.
I can recommend copper brazing rods Ø 3mm
I didn't use any glue.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
