Thingiverse
Tablet Stand
door FLX3D
3
Downloads
12
Likes
0
Makes
This is a tablet stand where you can adjust the angel: 45, 60 or 82 degrees. I made it because i didn't have a stand which works in the bed / on the blanket. This one is perfect.
If you have a bigger or smaller tablet / phone device you can change the length of the metal bars.
The Print takes about 1,5 h.
Additional you need a metal bar approx. 60 cm long and a saw to cut it to the right length.
I can recommend copper brazing rods Ø 3mm
I didn't use any glue.
If you have a bigger or smaller tablet / phone device you can change the length of the metal bars.
The Print takes about 1,5 h.
Additional you need a metal bar approx. 60 cm long and a saw to cut it to the right length.
I can recommend copper brazing rods Ø 3mm
I didn't use any glue.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
