Thingiverse
Tablet Stand
por burke9119
0
Descargas
1
Likes
0
Makes
This is a Tablet Stand remix based on 3DPrinterNinja's
http://www.thingiverse.com/thing:190062.
Included are a 'Small' and 'Large" version of the stand.
I like the design because it prints relatively quickly and is sufficiently strong to hold a tablet. There are two sizes - small and large that use the same centerpiece. The parts may be glued together or just pushed together so the stand can be disassembled for carrying in a travel bag.
The parts may require a bit of sanding or trimming with an exacto knife to get a snug fit. Strongly recommend that four small stick on pads be added to the bottom to reduce slippage on smooth surfaces.
http://www.thingiverse.com/thing:190062.
Included are a 'Small' and 'Large" version of the stand.
I like the design because it prints relatively quickly and is sufficiently strong to hold a tablet. There are two sizes - small and large that use the same centerpiece. The parts may be glued together or just pushed together so the stand can be disassembled for carrying in a travel bag.
The parts may require a bit of sanding or trimming with an exacto knife to get a snug fit. Strongly recommend that four small stick on pads be added to the bottom to reduce slippage on smooth surfaces.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
