Thingiverse
Tablet Stand
door burke9119
0
Downloads
1
Likes
0
Makes
This is a Tablet Stand remix based on 3DPrinterNinja's
http://www.thingiverse.com/thing:190062.
Included are a 'Small' and 'Large" version of the stand.
I like the design because it prints relatively quickly and is sufficiently strong to hold a tablet. There are two sizes - small and large that use the same centerpiece. The parts may be glued together or just pushed together so the stand can be disassembled for carrying in a travel bag.
The parts may require a bit of sanding or trimming with an exacto knife to get a snug fit. Strongly recommend that four small stick on pads be added to the bottom to reduce slippage on smooth surfaces.
http://www.thingiverse.com/thing:190062.
Included are a 'Small' and 'Large" version of the stand.
I like the design because it prints relatively quickly and is sufficiently strong to hold a tablet. There are two sizes - small and large that use the same centerpiece. The parts may be glued together or just pushed together so the stand can be disassembled for carrying in a travel bag.
The parts may require a bit of sanding or trimming with an exacto knife to get a snug fit. Strongly recommend that four small stick on pads be added to the bottom to reduce slippage on smooth surfaces.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
