TerraTrike Accessory Mount

Needs an 120mm Bolt and M6 Nut. Tightens into the derailleur mount. Can hold lights/computers/ most anything that will fit on a standard handlebar.

Ok this has been updated! The parts are now in separate files, this should make printing less terrible. I printed my wedges on the sliced flat side so they were stronger in compression than if they were printed in the same orientation as they're here. But it should work either way.

If you have a newer Terratrike Rambler, or the Gran Tourismo or anything else with a derailleur tube with an internal diameter of 28mm larger up to a point or external diameter of about 32mm.

Older Ramblers, Zoomers, anything with a tube of smaller diameter should use the 24.6mm files.