Thingiverse
Tevo_Endcap_Upperframe
por Coat
36
Descargas
20
Likes
0
Makes
[SEE ALSO VERSION 2: fits even better (PLA, room temperature), has a less thicker top and a less sloppy and geometrical correct logo. Also two extra models, https://www.thingiverse.com/thing:2868596 ]
Endcap for the upperframe of the Tevo Tornado with Tevo-logo for some extra bling. For printers of other brands (CR10?) with same frame-material there is a version without logo.Or customize your own cap with that one.
From both there is a version with hard/sharp and soft edges
Due to the mountings at the corners at the underframe, it doesn't fit there. Look at https://www.thingiverse.com/thing:2879063 for these caps.
Fits like a charm (PLA, room temperature), press it until it clicks in.
I printed these caps with the logo up, no support needed. You need a sticky bed,
but that is, to say the least, no problem with the Tornado with standard bed :)
Designed in Autodesk 123d
Sliced in Slic3r
Printed at standard Tevo Tornado
Endcap for the upperframe of the Tevo Tornado with Tevo-logo for some extra bling. For printers of other brands (CR10?) with same frame-material there is a version without logo.Or customize your own cap with that one.
From both there is a version with hard/sharp and soft edges
Due to the mountings at the corners at the underframe, it doesn't fit there. Look at https://www.thingiverse.com/thing:2879063 for these caps.
Fits like a charm (PLA, room temperature), press it until it clicks in.
I printed these caps with the logo up, no support needed. You need a sticky bed,
but that is, to say the least, no problem with the Tornado with standard bed :)
Designed in Autodesk 123d
Sliced in Slic3r
Printed at standard Tevo Tornado
Coat también publica en
73 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
