Thin Cable Cover (Cable Guide)

My first upload here :).

A thin (approximately 1cm W x 20cm L X 0.5cm H) cable holder that I made. The back has about a ~0.4cm wide slit to put the cable in, thus leaving ~0.6cm width that you can apply double sided tape or other adhesive on so this cover can stick against the wall. Print multiple and stick end-to-end for longer cable paths.

Use small supports to support the overhang, zigzag at 5% density with support interface disabled was perfectly fine. Then slide any tool down the slit to pop the supports off.

I've also attached the .f3d file.