Thin Cable Cover (Cable Guide)
door Abushawish
31
Downloads
19
Likes
0
Makes
My first upload here :).
A thin (approximately 1cm W x 20cm L X 0.5cm H) cable holder that I made. The back has about a ~0.4cm wide slit to put the cable in, thus leaving ~0.6cm width that you can apply double sided tape or other adhesive on so this cover can stick against the wall. Print multiple and stick end-to-end for longer cable paths.
Use small supports to support the overhang, zigzag at 5% density with support interface disabled was perfectly fine. Then slide any tool down the slit to pop the supports off.
I've also attached the .f3d file.
A thin (approximately 1cm W x 20cm L X 0.5cm H) cable holder that I made. The back has about a ~0.4cm wide slit to put the cable in, thus leaving ~0.6cm width that you can apply double sided tape or other adhesive on so this cover can stick against the wall. Print multiple and stick end-to-end for longer cable paths.
Use small supports to support the overhang, zigzag at 5% density with support interface disabled was perfectly fine. Then slide any tool down the slit to pop the supports off.
I've also attached the .f3d file.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
