Thingiverse
Thread tapping tool guide
por Thosam
45
Descargas
22
Likes
2
Makes
When building the D-Bot CoreXY 3Dprinter by spauda01 (http://www.thingiverse.com/thing:1001065), you need to tap M5 theads into several V-slots.
To help me keep the tapping tool centered and vertical, I designed this little tool guide that slides on top of the 2040 Vslot ends where needed.
Designed for an M5 thread tapping tool with less than 6 mm diameter, will work with similar tools of similar diameters.
To help me keep the tapping tool centered and vertical, I designed this little tool guide that slides on top of the 2040 Vslot ends where needed.
Designed for an M5 thread tapping tool with less than 6 mm diameter, will work with similar tools of similar diameters.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
