Thingiverse
Tiny Test Trophy
von TikiLuke
53
Downloads
48
Likes
0
Makes
A very small hollow trophy with .5mm to test overhangs and difficult details. I was having trouble printing overhangs even at 45 degree angles so I put this together to test an updated cooling setup on my printer. Hope it helps someone else test theirs.
*Edit* I added a tiny lid with rounded overhangs which is another geometry that causes me problems.
*Edit* I added a tiny lid with rounded overhangs which is another geometry that causes me problems.
TikiLuke veröffentlicht auch auf
7 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
