Thingiverse
Tiny Test Trophy
door TikiLuke
53
Downloads
48
Likes
0
Makes
A very small hollow trophy with .5mm to test overhangs and difficult details. I was having trouble printing overhangs even at 45 degree angles so I put this together to test an updated cooling setup on my printer. Hope it helps someone else test theirs.
*Edit* I added a tiny lid with rounded overhangs which is another geometry that causes me problems.
*Edit* I added a tiny lid with rounded overhangs which is another geometry that causes me problems.
TikiLuke publiceert ook op
7 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
