Thingiverse
Tron5.8 XT90 adapter
door tronhelicopters
1
Downloads
1
Likes
0
Makes
This is a EC5 holder for the Tron 5.8
Recommended to print it with ASA, no support needed for the holder.
2x M3x12mm Screws are needed to clamp the 2 parts around the connector. They can directly screw into the plastic without any pre-preparation, no Loctite or glue needed.
Recommended to print it with ASA, no support needed for the holder.
2x M3x12mm Screws are needed to clamp the 2 parts around the connector. They can directly screw into the plastic without any pre-preparation, no Loctite or glue needed.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
