Thingiverse
Type 2 Wall Socket
von northerncore
1
Downloads
1
Likes
0
Makes
type 2 wall socket for storing your charging cable when not charging.
the four holes for screwmounting should be around 4mm in diameter.
socket is a bit roomy, but it works.
printed with PLA since it's mounted inside a garage and not in the way of direct sunlight.
doesnt need support, but needs a bit of infill.
the four holes for screwmounting should be around 4mm in diameter.
socket is a bit roomy, but it works.
printed with PLA since it's mounted inside a garage and not in the way of direct sunlight.
doesnt need support, but needs a bit of infill.
northerncore veröffentlicht auch auf
19 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!