Thingiverse
Type 2 Wall Socket
door northerncore
1
Downloads
1
Likes
0
Makes
type 2 wall socket for storing your charging cable when not charging.
the four holes for screwmounting should be around 4mm in diameter.
socket is a bit roomy, but it works.
printed with PLA since it's mounted inside a garage and not in the way of direct sunlight.
doesnt need support, but needs a bit of infill.
the four holes for screwmounting should be around 4mm in diameter.
socket is a bit roomy, but it works.
printed with PLA since it's mounted inside a garage and not in the way of direct sunlight.
doesnt need support, but needs a bit of infill.
northerncore publiceert ook op
19 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!