Ultimate 64 - Console Case

Minimalistic case for _Ultimate 64_ FPGA board.

I've had an OG U64 board "lying around"; so I decided to create this console-like case for use in my living room.
The case only exposes the absolute necessary ports/connections (HDMI, USB, Joysticks, Power).
Fortunately the U64 can be fully operated using wireless/external keyboards and joysticks.
And with firmware 3.11 released, there's also Wi-Fi connectivity enabled; making it super easy to manage the device and upload new software.

Assembly instructions:
* print both baseplates and connect them
(you can use glue for more stability; but it should not be necessary)
* add threaded inserts for all screw holes on the baseplate
(I've used five M3x6x5 brass nuts for it)
* place the U64 board on the baseplate and fixate it using five M3 screws
* print both the left and right case parts
* slide the left case part over the baseplate and board; note the lower rails inside the case
* the right case has a tiny hole in front for a drive LED;